The report documents the design heating and cooling loads used for residential HVAC planning. Depending on the scope requested, it can show room-by-room loads or a block load for the home. Project factors reviewed may include: project location and local design conditions; floor area, room dimensions, orientation, and building layout; insulation and construction details; windows, doors, and skylights; air infiltration and ventilation assumptions; occupancy and internal heat sources; and planned HVAC equipment or system zones, when available. The available report scope and inputs depend on the project details you provide.
Start with your floor plans, project address, approximate square footage, and the services you want. Elevations and the following details help us refine the calculation: floor plans with room dimensions and layout; elevations and site orientation, if available; insulation R-values and construction details; window U-factor and SHGC, when available; doors, skylights, and other envelope details; planned HVAC equipment and system zones; and occupancy information when relevant to the project. Do not have every detail? Send what you have. We will identify missing information before the report is prepared.
A room-by-room load assigns heating and cooling loads to individual rooms, which can help the installing contractor evaluate distribution and equipment needs. A block load treats the home as one combined load. Manual J Express can quote either scope when available for the project. Room-by-room output is not included automatically in every order. Your quote will identify the requested scope.
Your Manual J PDF is a design-support report for HVAC planning and may support a permit submission when it matches your local building department’s requirements. It is not an engineering seal or a complete set of construction drawings, and it does not guarantee permit approval. The installing contractor verifies site conditions and makes the final equipment selection.
Manual J calculates the home’s heating and cooling loads. Manual S selects equipment from manufacturer data. Manual D addresses duct sizing and layout. A Manual J order does not automatically include Manual S or Manual D.